The following online preparations should be done before starting the working fluid system of the CNC EDM machine.
⑴Fill the clean working fluid bucket with water, connect the high-pressure water inlet pipe to the filter of the high-pressure system, connect the high-pressure water outlet pipe to the water inlet joint on the rotary head, and connect the low-pressure overflow water pipe to the joint on the guide plate. The flow valve connector is connected.
⑵ Check whether the lubricating oil in the high-pressure pump is sufficient. Observe the glass round window hole at the left end of the high-pressure pump. The lubricating oil must not be lower than the lower edge of the high-pressure pump.
(3) Insert the power plug of the working fluid system into the power socket at the back of the electrical cabinet.
⑷ Put the electrode on the rotary head, turn on the main power, and press the pump start button to start the working fluid system. It takes a few minutes after the second opening, and the working fluid will be ejected from the electrode. At this point, the adjustment of the working fluid system is completed.
Suzhou Lerjie Electromechanical Technology Co., Ltd. provides multi-axis CNC EDM small hole machine, multi-axis CNC EDM micro hole machine, high-speed EDM puncher, ECM electrolytic deburring, ECD electrochemical deburring machine, EDM tap tap Machine, CNC EDM, EDM machine tool technical services, the company can tailor a variety of EDM machines according to customer special requirements, and can provide customers with a complete set of electrical processing solutions.